For sale is a 1985 Alumacraft flat bottom 15' with a 1985 Yamaha 30 horse model number 30ELK. I would like $1600 OBO. I'm open to offers on this as I dont need it sitting around.

Boat is 15" all Aluminum with new grey carpet. The beam is 59" across the top. The bottom part of the boat is 39". Comes with 4 seats. 2 are pictured that have covers over them. The other 2 seats aren’t pictured are new. Has a livewell near the front of the boat. It has a pump and everything it just has to be hooked up. I used it for storage. Has lights hooked up and trolling motor plug on bow for trolling motor. Also has a lot of storage under the bow area. This is a console boat but could be converted to a tiller handle. Comes with anchor, ropes, and other stuff. It’s a pretty much ready to go boat.

Trailer was sandblasted and painted black last year. So there is no rust and everything on the trailer was re wired following the painting. So the trailer is like new.

The motor is a 1985 Yamaha 30 horse model number 30elk. The 30 stands for 30 horse, E stands for electric start manual tilt, L stands for 20" shaft length, and K stands 1985. It requires a gas oil mix. Not sure of correct term for that. I have never had one problem with it. Has electronic ignition and has started every time for me. Never really used the motor much used the trolling motor more then anything. Overall the engine is in very good shape for a 1985. Only issue is that you might need a new throttle cable as the old one is getting worn out and sometimes it doesn’t work I think they cost around $30. Other then that that’s the only issue I know of.

Comes with an older motor guide trolling motor that is not pictured. Has foot control.

Reason I’m getting rid of this boat is because I bought a new bought instead. I was told by a buddy that it would be an ok duck hunting boat. I never duck hunted so I couldn’t tell you. I used it on the back waters of the Mississippi as it runs very shallow.

To see all pictures of the boat I currently have click the photobucket link. Im only going to upload a couple to the forum post so it loads faster. I tried making them as small as I could for the forums. Bigger full size photos are found in the photobucket link.

http://s191.photobucket.com/albums/z318/dafaulty1/BOAT/





Key words: jonboat, jon boat, johnboat, john boat, flatbottom, flat bottom, duck boat, Yamaha, Alumacraft

Any questions you can either email me or call me 507 884 6263. If you would like more pictures of a certain item just ask and I can send them to you. Boat is located in Chatfield, MN about 12 miles south of Rochester.

Brandon

Very nice rig! I wish I had the money, this is what I am looking for, and a nice price as well!

Reduced price to $1800 or best offer. As I would like to get rid of it.

Do you know how tall the transom is on this boat?

I believe its 16" I will double check tomorrow when I get time. There is also some sort of jack plate that was attached to it when I bought it. So that helped lift the motor out of the water a little further also.

I double checked and it is about 16".

Update.

Price reduced again.

Update price reduced again...

That's exactly where I'd use it. Good luck!

May be interested. Sent you an e-mail.

If u sent me an email I didnt ever get it.

a_cad1, I must have screwed it up some how. Could you e-mail the photos to me? And I can get back to you with a few questions. Thanks!
danbarff@hotmail.com

I would love love to put my 115/80 ob jet on this boat and run it up the mn river once. Wish I had the mony sitting around:(