the last couple times I have used it it has a steady stream of water coming out however, the water seems to be mutch hotter than usual. Also when I shut the motor off just after it has run I hear a steam/sizzle sound and am worried that it is running too hot. Has anyone had this happen to them or have an idea what this might be.

Thanks

if I remember correctly the water stream is before the
Theromstat,
also the age tells me that the thermostat might not be working correctly, Is the head hot to touch??
If it is I would replace it, if you want to test the thermostat
just pull it out before you go and use it, it will not hurt the motor with it out for awhile
But remember run it in water to test so not to burn the impeller up.
By the way when was the impeller changed out??

Good Luck

Its hot if its your hear a steam sizzle. If its pumping water I'd also pull the thermostat. Look for debris clogging it. If it looks clear test it in hot water. You'll need a thermometer. Anything around 140 degrees is good.

I should do an impeller change as well. have not done it for about 5 yrs so its probably due. however it still has a good stream. The head is hot to the touch as well. I have never done a thermostat replacement. where is it even located and also is it just a thermostat or do I need to replace gaskets etc. as well

Can you get me the model number of your motor? If so, I can post a exploded view.

marine_man

is the model number on the motor somewhere like a car has a vin number on the driver side? I will take a look tomorrow when I get home from work. Thanks everyone and thanks marine man that will be great if I can find a model number

The thermostat is located on the head. You'll find a plate with the serial and model number located on the side of the motor bracket.

Frank is right, it's on the head. I think it's toward the lower end of the head, but I can get you a better feel for it with the model number.

marine_man

here are the numbers the plate read: E15RCTA is the first one and the second is: E0202904. Thanks again for all the help everyone.

MN Angler

1983
Lower right side of the head.

wow thats neat so it is newer than I thought it was. I bought it 6 or 7 years ago from a guy in southern MN and he said it had been sitting in his garage for over ten years and he told me he thought it was a late 70s. thanks surface Tension you have been a lot of help

MN Angler

Yep, lower rh side of the block, and there is a gasket:

The thermostat is #19 in this picture



marine_man

Thanks marine_man this is awesome to have a break down of it. I really appreciate it

MN Angler